

FLOW · Plant ring
Watering Reservoir
A water reserve around your plant. Use direct drainage or add a cotton wick for slower watering.
View on MakerWorldChoose your version
- S · 600 ml full ring
- M · 900 ml full ring
- L · 1,200 ml full ring
- XL · 1,600 ml full ring
At a glance
- Construction
- Two-part ring
- Modes
- Direct drain or cotton wick
- Sizes
- S, M, L, XL
- No supports
Made for everyday use.
Place one half or two mirrored halves directly on the soil around your plant. Without a wick, poured water drains through the outlet holes. For slower watering, thread cotton cord or yarn through the two holes and leave both ends in contact with the soil. Adjust the wick length, thickness and position for your setup. Four ring sizes are available, with full-ring capacities from 600 to 1,600 ml and separate single-size print profiles.
Wick material is not included. Watering duration depends on the wick, plant, soil and conditions. Test the flow before leaving a plant unattended. Images include existing explanatory visualizations.
From model to object.
Open the model on MakerWorld, choose the version and check the current print instructions. Download there or open a compatible profile in Bambu Studio.
Digital design for 3D printing. No physical product is shipped. For commercial sales of physical prints, see the Component membership ↗.
Watering Reservoir · Two-part ring
More height.
More water.
Four sizes. The same footprint.
Slide to see your reservoir grow.

Capacity is for both halves together. Use direct drainage or add a cotton wick. Test the water flow for your plant and soil.
Field manual / Watering Reservoir
FROM PRINT
TO PURPOSE.
01Before you print.+
Choose a capacity and print the matching halves shown in the guide.
02Set up and use.+
Fill and observe your setup. Adjust watering to the plant and growing conditions.





01 / 05



